Yawa Type I Easy to Paste Ceramic Tile Adhesive
Yawa Type I Easy to Paste Ceramic Tile Adhesive
Product Briefing
This product is made by mixing high-quality cement, graded aggregates, and various high-quality additives. The careful proportioning and high-quality raw materials make the product have super strong bonding strength. This product is ready to use with water, and compared to traditional cement mortar, it is easier to lay and apply. Thin pasting can effectively save space loss, labor, and time.
Product Features
Strong adhesion
Thin stickers save space
Clean and environmentally friendly
Product specifications
20kg/bag
Scope of application
Suitable for indoor concrete, cement mortar, and polymer cement waterproof coatings.
Suitable for ordinary ceramic tiles, ceramic mosaics, etc. with a water absorption rate of ≥ 6%.
Execution standards
GB/T 25181-2019 DTA-I type
Construction method
Base treatment
Clean the floating ash and loose layer on the wall with a flat shovel, and there should be no oil stains or oily release agents that are not conducive to tile adhesion.
After the completion of the concrete surface, it should be cured for at least 28 days before laying.
The newly plastered surface should be cured for at least 7 days before laying.
Old concrete and plaster surfaces can be cleaned with industrial detergents or degreasers, and then rinsed clean with high-pressure faucets. The surface can only be laid after drying for 24 hours.
For substrates with high water absorption or in high temperature and dry environments, it is best to wet the base surface to a dry outside and wet inside state before construction.
Brick material processing
Before painting, wipe the back of the tile with a damp cloth to remove any substances that may affect the bonding, such as release powder, oil stains, and protective agents. The release agent on the back of the tile must be cleaned thoroughly.
Material mixing
Estimate the material usage in advance based on the construction area, add clean water to the mixing bucket, and slowly add powder (powder: clean water ratio is about 4:1~5:1) while mixing. Use an electric mixer to mix evenly without clumping, let it sit for 5-10 minutes, and then mix thoroughly again before use.
Construction operation
Use a toothed scraper to evenly apply the tile adhesive onto the base surface, with a maximum area of 1 square meter each time. Then, use a toothed scraper to evenly apply a layer of tile adhesive on the back of the tile, and finally stick the tile onto the base surface.
Precautions
施工环境温度应在5-35℃。
陶质砖无须泡水，如泡水必须将瓷砖背面晾干后进行铺贴。
搅拌好的砂浆不宜放置过久，2小时之内完成施工最佳。
严禁在调配后已干结的胶浆中加水混合后再次使用。
严禁掺加其他材料改变瓷砖胶的配比和性能。
产品开封后建议一次性使用完。
Reference amount
理论耗量每平方米1mm 厚度用量约为1.5kg，实际用量根据铺贴情况进行调整。
Transportation and storage
运输过程中避免雨淋和日晒，保持包装完好。需储存在阴凉干燥的仓库内，防止受潮，严禁与水接触。
存储期：12个月。
